Al-Quds University - Department of Material Engineering

Tarek Abu Leil

Assistant Professor of Metals and Alloys

Research interests

Development of new magnesium alloys for automobile industry.
Development of new magnesium alloys for biomaterials.
Diffusion brazing of TiAl alloys as repair technique.
Development of new adhesive bonding.
Design and development of a Heating, Ventilation, and Air-Conditioning (HVAC) system - comparison of the Refrigerant of the R134a and CO2
Quality analysis of automobile transmissions and engines.
Full CV

Teaching

Selected Publications

T. Abu Leil; K.P. Rao; N. Hort, C. Blawert, W. Dietzel, Y. Huang, K. U. Kainer, Microstructure and Corrosion behaviour of Mg-Sn-Ca alloys after extrusion, Journal of Transactions of Nonferrous Metals Society of China, Vol.63, (2009).
A. Kozlov, M. Ohno, T. Abu Leil, N. Hort, K. U. Kainer and R. Schmid-Fetzer, Phase equilibria and Thermodynamics of the Mg-Sn-Ca system, Part 2: Experimental Investigation of ternary Mg-Sn-Ca phase equilibria and solidification microstructure, Journal of Intermetallics, Vol.16, (2008).
Y. Huang, H. Dieringa, N. Hort, T. Abu Leil, K. U. Kainer, Effects of segregation of primary alloying elements on the creep response in magnesium alloys, Scripta Materialia, Vol.58, (2008).
Y. Huang, T. Abu Leil, N. Hort, K. U. Kainer and Yilin Liu, Effect of Microstructural Inhomogeneity on Creep Response of Mg-Sn Alloys, Key Engineering Materials, Vol.345-346, (2007).
T. Abu Leil, Y. Huang, H. Dieringa, N. Hort, K.U. Kainer, J. Buršík, Y. Jirásková and K.P. Rao, Effect of Heat Treatment on the Microstructure and Creep Behavior of Mg-Sn-Ca Alloys, Materials Science Forum, Vol.346-549, (2007).

tarek-abu-leil

Contact information

Department of Materials Engineering.
Room 104
Faculty of Engineering
Al-Quds University.
Abu Dies, Palestine.

Tel: +970 (0)2 2795152
Tel-fax: +970 (0)2 2797023

Email: This e-mail address is being protected from spambots. You need JavaScript enabled to view it.